Brutkey

smells of bikes
@smellsofbikes@mastodon.social

As I said once it's hot things happen quickly so I didn't take a pic of dumping in boric acid or the actual pour. I'm very busy right then. But I did get both molds filled and dumped the excess (I melt way more than needed in case I miss the pour basin and waste some) into a muffin tin. The aluminum is still very molten here so it has a mirror reflection aside from a bit of dross.

Poured molds Aluminum reflecting the sky and clouds
smells of bikes
@smellsofbikes@mastodon.social

One mold had a blowout and lost about 300ml of aluminum out the bottom into the sand but both filled well. I have not finished cleaning them yet so the inner passages are still full of investment.
The tapered helical spiral sprue and pouring basin worked really well. It choked and remained full the whole pour, not entraining any air. That was the main point of this. There was some grubby stuff in the pour visible in one mounting boss and one lip of the intake didn't fill entirely. Still ok.

Rubbish in the aluminum including ash from the PLA burnout Little lacunae in the edge of the intake pipe. I could weld this. Both sides, one with the helical sprue very obvious and the almost empty pour basin above it
smells of bikes
@smellsofbikes@mastodon.social

Here's a video of one intake cut loose from the gate system and the other as cleaned up but still gated to show how the gating worked. I'm very happy with this.
I do have to figure out how to make the gating easier to remove. Long flat contact is really frustrating to cut loose.